How to fix no display message on ELGA PURELAB Option-R 7 Water Dispenser?
If there is no display message on your ELGA Water Dispenser, verify the mains supply and lead are properly connected. Ensure the mains power is switched on. Also, inspect the fuse in the power inlet module and replace it if it's blown.
What to do if ELGA PURELAB Option-R 7 output flow is outside specification?
If the output flow of your ELGA Water Dispenser is outside the specified range, start by checking the supply pressure. Then, compare the RO flow-rate of your unit against the graphs detailed in Section 3.3 of the manual, paying attention to treated water output in relation to temperature and feedwater pressure. Ensure the inlet strainer and receiver strainer are clean. If necessary, consider contacting a service technician to install or replace an optional booster pump.
What to do if the reservoir low level audible alarm sounds on my ELGA Water Dispenser?
If the reservoir low level audible alarm sounds on your ELGA Water Dispenser, you can press the crossed bell button to mute the alarm. The reservoir should then automatically refill. Check that the process mimic shows the reservoir filling. Also, verify the feedwater supply and the connections to the reservoir.
How to fix no flow from dispense tap on ELGA Water Dispenser?
If there is no flow from the dispense tap of your ELGA Water Dispenser, push the PROCESS button. Also, ensure that the reservoir level is above 40%.
What to do if UV lamp failure audible alarm sounds on ELGA PURELAB Option-R 7 Water Dispenser?
If the UV lamp failure audible alarm sounds on your ELGA Water Dispenser, you can press the crossed bell button to mute the alarm. Check that all electrical connections are secure. When applicable, follow the UV lamp replacement procedure. You can also temporarily continue operation without the UV lamp if necessary.
How to stop ion-exchange cartridge replacement alarm on ELGA Water Dispenser?
If the ion-exchange cartridge replacement alarm is active on your ELGA Water Dispenser, replace the ion-exchange cartridge pack.
What to do if pre-treatment cartridge replacement alarm sounds on ELGA PURELAB Option-R 7?
If the pre-treatment cartridge replacement alarm is active on your ELGA Water Dispenser, replace the pre-treatment cartridge.
Details electrical safety precautions, including earthing and power isolation.
Explains procedures for isolating and releasing pressure before maintenance.
Step-by-step instructions for connecting water tubes and electrical supply.
Guide to configuring system preferences and settings upon first use.
Procedures for the first-time operation and rinsing of the unit.
Details various alarms, their causes, and how to respond.
Step-by-step guide for replacing the pre-treatment cartridge.
Instructions for removing and installing the ion-exchange cartridge pack.
Lists specific alarm icons and the conditions they represent.
General| Brand | ELGA |
|---|---|
| Model | PURELAB Option-R 7 |
| Category | Water Dispenser |
| Language | English |
To Next Page
