Need help?Do you have a question about the Elgato WAVE:3 and is the answer not in the manual?
General| Type | Condenser |
|---|---|
| Polar Pattern | Cardioid |
| Bit Depth | 24-bit |
| Dynamic Range | 110 dB |
| Interface | USB-C |
| Headphone Output | 3.5 mm |
| Mixer Software | Wave Link |
| Built-in Pop Filter | Yes |
| LED Indicator | Yes |
| Frequency Response | 70Hz - 20kHz |
| Sample Rate | 96kHz |
| Max SPL | 120dB |
| Capsule | 17 mm Electret |
Download and install the Elgato Wave Link Software from the provided URL.
Plug the provided USB-C cable into the USB-C port on the microphone.
Plug the USB-A plug of the cable into an available USB-A slot on your computer.
Connect headphones to the 3.5mm headphone jack on the back of the microphone.
Ensure the microphone capsule faces you, angled slightly towards your mouth.
Place the microphone approximately two fists (6 inches) away for optimal sound.
Keep gain low (around 40%) to minimize background noise.
Tap the capacitive mute button for instant, silent muting.
ClipGuard Technology analyzes audio to prevent peaks from plosives or shouting.
Wave Link software allows control of Wave:3 and other sources for two output mixes.
Use the dial to adjust Mic Gain, Headphone Volume, and Mic/PC Mix Monitor.
Combine Wave:3 with Stream Deck and Wave Link for advanced A/V automation.
Configure Zoom settings to use Wave:3 as the microphone input.
Configure Microsoft Teams settings to use Wave:3 as the microphone input.
To Next Page