1 General
1.1 Information Operating Manual
This manual contains important information regarding the handling of the device.
For your own safety and operational safety, please observe all safety warnings and instructions.
Precondition for safe operation is the compliance with the specified safety and handling instructions.
Moreover, the existing local accident prevention regulations and the general safety rules at the site of operation
have to be observed.
Please read the operating manual carefully before starting to work with the device!
It is part of the product and should be kept close to the device and accessible for the staff at any time. The illus-
trations in the manual are for better demonstration of the facts. They are not necessarily to scale and can slightly
differ from the actual design.
1.2 References
/CO_SPECS/ LIMAX Safe SG/SC CANopen Specifications https://support.elgo.li/man/D-100968
/SENS_MANUAL/ Operating Manual LIMAX33 RED https://support.elgo.li/man/D-100218
Operating Manual LIMAX44 RED https://support.elgo.li/man/D-103836
/CiA DR303-3/ CiA Draft Recommendation 303, Part 3: Indicator specification; CAN in Automation
1.3 Terms and Abbreviations
Number of floors and positions of the floors of the lift where LIMAX Safe SG/SC is installed
Synonym: floor image
Synonym: inspection control, inspection pod
Remark: the EN81 talks about “inspection control station”
Synonym: recall control, emergency control, recall pod
Remark: one will not find this term in the EN81.
There one can find: “means of emergency electrical operation”, “emergency electrical oper-
ation switch”, “emergency electrical operation button” for the devices an “emergency electri-
cal operation” for the process. These terms are not used here because they are very long
Synonym: lift control, elevator control
Complete system (Safe Box, LIMAX33 RED/LIMAX44 RED and magnetic tape).
A device may be a LIMAX Safe SG or a LIMAX Safe SC. The type of the device (SG or SC)
cannot be changed. The type SG/SC is noted on the identification label. Some con-
straints/hints/instructions for use are each only applicable for LIMAX Safe SG respectively
LIMAX Safe SC.
These special paragraphs in this manual are clearly marked. The instructions for the present
device must be followed. The instructions for the other type cannot be followed.
Concrete type of the LIMAX SG/SC: SGC must be connected to an external electromechani-
cal actor. This actuator may operate a suitable safety gear directly or it may operate a con-
ventional safety gear indirectly by blocking the speed governor.
Concrete type of the LIMAX SG/SC: SGC must be wired in the safety circuit. No operation of
safety gear- neither directly not indirectly – is provided by LIMAX Safe SC.
Component of the overall system LIMAX Safe, safe position sensor up to 262 m
Component of the overall system LIMAX Safe, safe position sensor up to 786 m
To Next Page
Loading...
Need help?
General
