11
17. Open the front door, remove the grease filter (see
paragraph "Maintenance - Front Door" and
"Maintenance - Grease filter") and secure hood with 2
screws on bottom.
18. Ducting version - vertical discharge ONLY:
Install the transition on top of the hood with 2 screws.
Connect ducting to transition. Seal with duct tape.
Do not use duct smaller than the transition.
Ductless (recirculating) version ONLY:
Install the deflector (available as an extra kit). on top of
the hood.
19. Electrical connection
WARNING
Electrical Shock Hazard
Warning: Turn off power circuit at the service panel
before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE
MUST BE CONNECTED TO THE GROUNDING WIRE
IN YOUR HOME ELECTRICAL SYSTEM, AND IT
MUST UNDER NO CIRCUMSTANCES BE CUT OR
REMOVED.
Failure to do so can result in death or electrical
shock.
On top of the hood on the right side is found the
Junction box, remove the knockout and the Junction box
cover and install the conduit connector (cULus listed) in
junction box cover.
Run 3 wires; black, white and green ,according to the
National Electrical Code and local codes and
ordinances, in 1/2" conduit from service panel to
junction box.
Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
Close and secure junction box cover.
To Next Page
Loading...
Need help?
General
