8
UC IR REMOTE CONTROL
The UC IR (sold separately) infrared remote gives you control of various functions (See below). To
control the xture you must aim the remote at the front of the xture and be no more than 30 feet away.
To use the ELIMINATOR UC IR you must rst activate the xtures infrared sensor, to activate the
sensor please see the instructions on page 23.
CONTROLS
STAND BY - Pressing this button will blackout the xture. Press the
button again to return to the initial state.
FULL ON - Press this button to fully light up the unit.
FADE/GOBO - This button can activate color change mode, color
fade mode, or combination color change and fade mode. Each
press of the button will switch through the 3 different modes. Use
the numeral buttons 1-9 to select the program number within your
desired mode. Use the dimmer buttons to adjust the output intensity.
Note: Running speed is not adjustable using the IR control functions.
Example: In color change mode (AJXX), press the numeral buttons
“1+3” to run color change program “13”. In color fade mode (AFXX),
press the numeral button “7” to run color fade program “7”. Note:
Color change and fade combination mode has only one program.
“DIMMER +” and “DIMMER -” - Use these buttons to adjust the
output intensity in operating mode.
STROBE - Press this button to activate strobing. Use buttons 1-4 to
adjust the strobe speed. “1” being the slowest, “4” being the fastest.
COLOR - Press this button to activate color macro mode. Use the numeral buttons 1-9 to select your
desired color. Use the dimmer buttons to adjust the output intensity.
Numeral Buttons 1-9 - Use buttons 1-9 to select your desired color in static color mode, or your desired
program in color fade mode and color change mode. In static color mode, color fade mode, or color
change mode, press the corresponding numeral buttons to select your desired color or program.
SOUND ON & OFF - Use the buttons to activate and deactivate sound active mode.
SHOW 0 - Press this button along with any single numeral button to access a static color, or program
within color change mode and color fade mode.
To Next Page
Loading...