Elite Screens Kestrel Series How To Replace

Rev111010-ESC
www.elitescreens.com
How to replace a Kestrel Series circuit board
1. Raise the screen about 2 feet,
and then unplug the power cord.
VERY IMPORTANT: Use rope to
tie the screen from both ends
after raising it. When removing
the end cap, the screen will
spring open and can cause
serious injury and can
permanently damage the screen.
2. REMOVE the 6 screws as
shown on the picture marked
in red.

Elite Screens Kestrel Series Specifications

General

Frame Material	Aluminum
Frame Color	Black
Aspect Ratio	16:9
Gain	1.1
Viewing Angle	160°
Features	Floor Rising