A
locking bolt
frame
leg
frame spacer
ttaching the Frame to its Supports
1. Always use at least two locking bolts through the T-Leg Support, the Spacer and into the Frame on each side.
2. Height can be adjusted in 8” increments up or down. Normal screen height is 44” from the bottom of the frame to
the floor.
3. Reverse this process to dismantle and pack away the screen.
snap latch button
Folding the Picture Surface for Packing
Please observe the following precautions before folding up the screen material.
1. Do not bring the viewing surface into contact with chemical solvents, sharp or abrasive objects, painted,
varnished or plastic finished items.(*See the cleaning instructions for exceptions to this)
2. Make certain that the screen is laid out on a dry, clean and flat surface.
Folding up the screen:
Lay out the screen with the viewing surface facing up and cover it with flat (not crumpled) tissue or packing paper that is
clean and unprinted. *Note: Do not ever use abrasive paper, newspaper or any printed material on your projection
screen.
To Next Page
Loading...
Need help?
General
