Rev. 03/15/17 1 www.elitescreens.com
How to Re-Tension the Roller
for Yard Master Manual Series
For technical support or further assistance, call 877-511-1211 x604
Tools Required: 1 Small Blade, 1 Phillips screwdriver, 1 Mallet, Thin Rope or Twine, Double Sided Tape or Glue
Repair method:
1. Carefully remove the aluminum face plate from the left side end cap when facing the front of the screen.
Insert the small blade behind the face plate in one corner to separate it from the end cap, then peel the rest
off with your hands. Be careful not to excessively bend the face plate.
2. Utilize the Phillips screwdriver to remove the screws from the left side end cap. Remove the end cap.
Note: After loosening the screws and removing the end cap, the roller may spin due to the tension that may
be remaining within the roller. If the end cap spins with this remaining tension, it can cause an injury to your
hand. Please handle the end cap and roller with care.
To Next Page
Need help?
General
