4
ATTACH/DETACH HANDLE (CONT.)
CAUTION: Ensure the Temperature Dial is set to “OFF,” the Power Cord is
unplugged from the electrical outlet, and the product has thoroughly
cooled before attaching or detaching the Handle.
To attach:
1. Align the electrical pins of the Base with the electrical pinholes of the
Handle.
**Ensure the Locking Lever is in the raised/vertical position**
2. Slide the Handle until it locks into position on the Base.
3. Push down the Locking Lever so it securely locks into the tab recess.
4. The handle should be secure and not fall off. If the handle is loose, then
the locking lever was not properly engaged. Return to step-1 and
repeats steps 1-3.
To detach:
1. Slightly push the Locking Lever tab away from the tab recess.
2. Push the Locking Lever to its raised/vertical position.
3. Remove the Handle from the Base.
NOTE: Do not twist or bend the Handle when removing it from the
Base, as product damage may result.
4. Push down the Locking Lever so it securely locks into the tab recess, for
proper storage.
USING YOUR SKILLET
NOTE: Thoroughly clean the product before using it for the first time.
CAUTION: Do not touch hot surfaces. Always use the Handle and knobs of
the product when handling. Use protective oven mitts or gloves to avoid
burns or serious personal injury.
1. Place the product on a flat, stable, heat-resistant surface.
2. Ensure the product is unplugged from the electrical outlet and the
Temperature Dial is in the “OFF” position.
3. Follow the “To attach/detach the Handle”
procedure to attach the Handle.
4. Lightly coat the entire cooking surface with
cooking oil of choice. Repeat as necessary.
5. Plug the Power Cord into a standard 120V AC
electrical outlet.
6. Preheat the skillet uncovered for about 30-45
seconds using the “MAX” setting.
To Next Page
Loading...
General