8
Trouble Shooting continued
Hoses are
twisting
The hoses twist if they have been coiled up during storage, take
the hose apart lay it flat on the ground for a day in bright sunshine,
reassemble and use as normal
i.
Pool Cleaner
does not clean a
specific area of
the pool
Turn the hose connected at the weir one quarter turn, this should solve
the problem and can be repeated if necessary
i.
The Cleaner will
not climb the
walls of the pool
Please ensure the footpad is fitted properly to the cleaner
If the radius between the floor and the wall is to narrow, the cleaner will
not climb the wall
A Poolmaid Square Pool Attachment can be connected to solve this
problem or if the angle is too steep (90 Degrees) an Xplorer Turbine
cleaner may be purchased as an option
i.
ii.
iii.
The Pool Cleaner
disc does not lie
flat on the pool
Floor floor
Adjust the clip on weight until the balance of the units is correct i.e. the
disc lies flat on the pool floor and ensure the hose does not have any
air in it (refer to pg 4).
i.
Vacuum
Plate
Flo n Show
weir valve
45° elbow
Pool Hose
Weir adaptor
Water Level
Connection to Skimmer
Points (Australia only)
To Next Page
Loading...