Elite Pool Cleaner - Pre-installation Checklist; Once Unpacked; Bump Strip Installation

2.
1.
4
Once unpacked:
Step 1
Attach the Elite Pool Cleaner
disc by placing the disc over
the body (see figure 1) and
positioning it below the wings
(figure 2).
The disc must be attached
with the fins on top and the flat
surface facing down. Disc is
marked “Top”.
The disc should rotate freely.
1.
2.
3.
The clip on weight has been set by
the factory for most pools. If the Elite
Pool Cleaner tilts to the front move
the clip on weight to the lowest clasp
Step 3
Insert the bump strip into the
slots provided. Insert the bottom
end first until the bump strip
clicks into position and then
insert the top end.
1.
Step 1
Step 2
(Fig. 1)
(Fig. 2)
Pre-installation Checklist
Front Back
Wings