To Next PageTo Next Page
Need help?Do you have a question about the Elkay EZ Series and is the answer not in the manual?
General| Voltage | 115V |
|---|---|
| Material | Stainless Steel |
| Filter | Optional |
| Filtration | Optional |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Type | Water Cooler |
| Activation Method | Push Bar |
| Model | EZ Series |
Steps for mounting the cooler onto the hanger bracket and connecting utilities.
Initial steps for powering up and testing the unit.
Guidelines for cleaning the exterior panels of the EZ coolers.
Instructions for removing the lower and upper shrouds for system access.
Procedure for removing and servicing the bubbler assembly.
Explanation of push bar switch operation and installation notes.
Steps for installing the wall mounting plate for the bottle filler.
Connecting the bottle filler unit to the cooler and water supply.
Performing leak checks, power-up tests, and final assembly.
Procedures for verifying software and accessing programming buttons.
Managing filter status and setting filter capacity.
Configuring the IR sensor range and unit type.
Procedure to reset the bottle counter.
Steps for disassembling and moving components on the refrigerated cooler.
Steps for disassembling and moving components on the non-refrigerated cooler.
Instructions for moving the filler panel and j-clip for specific mounting.
Procedure for swapping drain parts in the shroud.
Reconnecting components for refrigerated and non-refrigerated coolers.
Important precautions during basin/shroud assembly replacement.
Instructions for installing the left-hand wrapper in the high position.
Instructions for installing the left-hand wrapper in the low position.
Instructions for installing the right-hand wrapper in the low position.
Instructions for installing the right-hand wrapper in the high position.
Plumbing diagram for standard EZ bi-level pressurized coolers.
Plumbing diagram after filter installation and bottle filler line addition.
Notes on tightening the nut for bubbler and pedestal replacement.
Procedure for cleaning the solenoid valve strainer and reassembly.
Wiring diagram for 115V non-refrigerated units.
Wiring diagram for 115V refrigerated units.
Instructions for attaching and releasing tubes using quick connect fittings.
List of parts for the WaterSentry Plus filter assembly.
List of replacement parts for the cooler assembly.
List of replacement parts specifically for the bottle filler.
