EasyManua.ls Logo

Elkay ezH2O Liv Pro - User Manual

Elkay ezH2O Liv Pro
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
(630) 574-8484 1 Elkay Manufacturing Company
Installation Manual (1000005849 Rev. B - 04/21) In-Wall Filtered Water Dispenser
LBWD2C00BKC LBWD2C00WHC
Installation Manual
ezH2O® Liv Pro Commercial In-wall Filtered Water Dispenser 220-240V
LBWD2C00BKC
LBWD2C00WHC

Questions and Answers

  • M
    michellemcfarlandJul 28, 2025
    What to do if my Elkay ezH2O Liv Pro Water Dispenser has no water flow?
    • P
      Peter ThompsonJul 28, 2025
      If your Elkay Water Dispenser has no water flow, here are some things to check: * Ensure the unit has electrical power. * Verify that all water shut-off valves are open; check inside the filter box (if installed) and at the water source. * Inspect the bottle sensor for proper operation; a malfunctioning sensor will need replacement. * Look for any blocked or damaged water lines and clear any obstructions or repair damage.
  • S
    schneidermaryAug 3, 2025
    Why is the water flow low in my Elkay ezH2O Liv Pro?
    • L
      luke01Aug 3, 2025
      There are several reasons for low water flow in your Elkay Water Dispenser: * The supply water pressure may be less than the required 40 to 105 psi. * The filter might be plugged and needs replacement. * The solenoid water valve may not be opening fully, requiring replacement.
  • T
    Timothy JohnstonAug 9, 2025
    What to do if Elkay ezH2O Liv Pro Water Dispenser runs continuously?
    • D
      Derrick SmithAug 9, 2025
      If water runs continuously from your Elkay Water Dispenser, it could be due to: * A defective or dirty sensor, in which case you should clean or replace the sensor. * A defective solenoid or solenoid diaphragm, requiring replacement of the solenoid water valve. To verify a faulty solenoid, disconnect the power while water is running; if the water flow doesn't stop immediately, replace the solenoid.
  • K
    Kelly CoxAug 15, 2025
    Why is the red light blinking on my Elkay ezH2O Liv Pro Water Dispenser?
    • D
      Donna GonzalezAug 15, 2025
      A blinking red light on your Elkay Water Dispenser typically indicates a filter issue. It could mean that there is no filter installed, so you should replace the filter. Alternatively, the filter may be incorrectly installed, so ensure it is completely installed.
  • C
    Chad JacksonAug 21, 2025
    What does blinking red and blue light mean on Elkay ezH2O Liv Pro?
    • M
      Michael BarberAug 21, 2025
      A blinking red and blue light on your Elkay Water Dispenser indicates that the filter wire is disconnected. Check the filter cable connections to resolve this.

Summary

Safety Precautions

General Safety Guidelines

General safety precautions and responsibilities for installation and maintenance.

Personal Safety and Protective Gear

Emphasizes using personal protective equipment and following power tool safety recommendations.

Electrical Safety and Shock Hazards

Highlights dangers of live electrical wiring, GFCI requirements, and disconnecting power.

Workplace Hazard Awareness

Warns about tripping hazards from tools and cutting hazards from sharp edges.

Installation Preparation

Installation Procedures

Cutting Size and Mounting Dimensions

Provides recommended dimensions for the wall opening and unit height from the floor.

Water Dispenser Installation Steps

Guides through cutting the opening, placing the unit, and attaching it to wall studs.

Electrical Power Connection

Details connecting the 220V/240V power supply to the unit and the gang box.

Remote Filter Installation Steps

Guides on how to mount the filter head remotely and connect it to the water dispenser.

Startup and Operation

Troubleshooting Guide

Water Temperature and Flow Issues

Addresses issues with water temperature, flow, and no water flow.

Elkay ezH2O Liv Pro Specifications

General IconGeneral
Installation TypeBuilt-in
FilterYes
MaterialStainless Steel
Power115V/60Hz
Product TypeWater Dispenser
Mounting LocationWall
ActivationSensor activated
ComplianceADA, NSF 42, NSF 53
FiltrationNSF 42 & 53 certified filter for lead, particulate, chlorine taste & odor reduction

Related product manuals