Ellison PRESTIGE SELECT - Operating Instructions; Using Standard Surecut and Clearcrop dies

5
Front
Figure A
Back
Pressure
Plate
Die
Material
Premium Cutting Pad
Figure B
Right Side
Left Side
Using Standard SureCut™ and ClearCrop™ Dies (Large, Small and Tiny)
1. Raise the handle all the way up.
2. Place material to be cut against the rubber side of the die and place rubber
side down on the Cutting Pad.
3. Slide the Cutting Pad to center the material and die under the Pressure
Plate (Figure A).
Note: Vary die placement from side to side to prolong the life of the
Cutting Pad (Figure B).
4. Lower the handle one time to cut through the material.
5. Keep a firm grip when raising or lowering the handle.
6. Slide the Cutting Pad out from under the Pressure Plate and remove the die
and perfectly cut shapes, letters and numbers.
Operating Instructions