Elma DT128 side 9
English usermanual
Introduction
This is the NON-contact Moisture Meter Elma DT128-M. It is an electronic dampness
indicator with a measuring process working on the principle of high frequency. The
instrument is used for non-destructively tracing dampness in building materials of all kinds.
As well as for detecting damp distribution in walls, ceilings and floors. It is particular
suitable for pre-testing the readiness of building materials for covering prior to CM
measurement.
Features
x Quickly indicate the moisture content of materials
x Measuring results is quoted in % material humidity
x Depth of penetration about 20-40mm
x Measure and HOLD function
x MAX/MIN display Function
x Alarm function
x Low battery indication
x Auto power off
x White Backlighting LCD display
Specification
Measuring Range 0,0 – 100,0
Penetration Depth 20-40mm
Resolution 0,1
Battery Three “AAA” batteries.
Front Panel Description
1. Moisture Sensor
2. LCD Display
3. MEAS-Button
4. UP/Backlight Button
5. ALARM SET Button
6. DOWN Button
7. ON/OFF Button
8. Battery Cover