This screen allows you to activate
(LOCK) or deactivate (UNLOCK) the
by pressing
the or buttons. This function is
suitable in self-service places, in order
to avoid people from changing the
values set.
.
KeyBoard
UNLOCK / LOCK
When the keyboard is locked, the
the display as shown on the screen
below:
a "
:
SLUSH
* X
If the machine is turned OFF and ON,
the electronic board will be in LOCK
position again.
Warning: The keyboard lock can be
activated if the electronic board is
in “Standby" or “MotorOn” mode.
.
"MotorOn".
Turning OFF and ON of the washing
function.
..
Washing
OFF / ON
If the function is active, the electronic
board will show the screen below:
::
Washing
In this condition all buttons and the
cooling functions are NOT active, a pat
from the MENU button.
, a
.
TIME
hh:mm
This screen shows the time set on the
machine.
.
TIME
hh:mm
If it is different from the place where
the machine is installed, you can
change it by following the steps below:
1) press the button;
2) the first value will start to blink. If
you want to change the value, you
need to press the button;
3) if you press the button;
4) the second value will start to blink.
If you want to change the value,
you need to press the button;
5) if you press the button;
6) the third value will start to blink. If
you want to change the value, you
need to press the button;
7) press the button;
8) the fourth value will start to blink. If
you want to change the value, you
need to press the button;
9) press the button to
exit this function. The time will be
saved.
Warning: During the time
adjustment, the date (MM/DD/YY)
will appear on the upper line. It can
be different from the date of the
place where the machine is
installed, but the machine will work
without any problem.
NOTE: First Class Millennium
BASIC does not display this screen
and all other screens here reported
in the dotted square. These will only
be active in the ADVANCED version.
:
1
;
2
3
4
;
5
;
6
;
7
;
8
;
9
..
.
.
Defrost function: On the screen you
can see the defrost ON and OFF time.
.
If the two values are the same, the
function is deactivated. In order to
change the ON and OFF time, follow
the steps below:
1) press the button;
To Next Page
Loading...
Need help?
General
