ELNA PRO 704 DEX - Important Safety Instructions; Danger: Risk of Electric Shock; Warning: Risk of Burns, Fire, Shock, Injury; Save These Instructions

HOUSEHOLD OVERLOCK SEWING MACHINES MODEL PRO 704 DEX
When using an electrical appliance, basic safety precautions should
always be followed, including the following:
Read all instructions before using the machine.
To reduce the risk of electric shock:
DANGER
The machine should never be unattended when plugged in.
Always unplug the machine from the electric outlet immediately after using and
before cleaning.
Always unplug the machine before replacing the light bulb. Always replace bulb with
the same type rated 15 volts/5 watts.
WARNING
Do not allow the machine to be used as a toy. Pay close attention when the machine
is used by or near children.
To reduce the risk of burns, fire,
electric shock or injury to persons:
Use the machine only for its intended use as described in this manual. Use only
attachments recommended by the manufacturer as contained in this manual.
Never operate the machine if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged or dropped into water. Return the machine
to the nearest authorized dealer or service center for examination, repair, electrical
or mechanical adjustment.
Never operate the machine with any air openings blocked. Keep ventilation openings
of the sewing machine and foot control free from accumulation of lint, dust and loose
cloth.
Keep fingers away from all moving parts. Special care is required around the sewing
needle and moving blade.
Do not use bent needies.
Do not pull or push fabric while stitching. It may deflect the needle causing it to break.
Switch the machine ‘‘OFF’’ when making any adjustments in the needle area, such
as threading needle, changing needle, threading looper, or changing presser foot and
the like.
Always unplug the machine from the electrical outlet when removing covers, lubricat-
ing or when making any other user servicing mentioned in the instruction manual.
Never drop or insert any object into any opening.
Do not use outdoors. Always store the machine indoors.
Do not operate where aerosol (spray) products are being used or where oxygen is
being administered.
To disconnect, turn all controls to the off position, then remove plug from outlet.
Do not unplug by pulling on cord. To unplug, grasp the plug not the cord.
The machine should be disconnected from the electricity supply when not in use.
lf the power cord of the machine is damaged, it must be replaced by special cord
by your nearest authorized dealer or service center.
“SAVE THESE
INSTRUCTIONS”
For U.S.A.
— The foot contro! type 4C-335B and/or 4C-316B should be used with the machine.
— This appliance has a polarized plug (one blade wider than the other).
To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the proper outlet. Do not modify
the plug in any way.