ELNA SP User Manual (English)

To Next Page

6 - Print the PDF pages number 1 through 11 (not the page numbers on the printed pages of the booklet!)

7 - Take the printed pages and stack them back in the paper tray. They need to be in order so that the top page is MANUAL PAGE #21&24 with the red

cover (this page) at the bottom of the pile. The ﬁrst page to be printed will be on the BACK of MANUAL PAGE 21&24.

8 - Place them back in the paper tray and print PDF pages 12-22

9 - Fold each sheet in half and assemble the book using the GREY PDF PAGE NUMBERS in the lower left corner with “1” on the bottom of the stack and “11”

on the top. You can trim the outer ends or leave them for note taking space if you like. Staple using a saddle or heavy-duty stapler

Test you printer:

1 - Print This Page.

2 - Put the page back in the printer with the blank side to be printed correctly oriented (varies with the printer). Remember how you did that (which way the

paper faced)!

3 - Print PDF page #22

4 - Fold the page down the middle with the cover on the outside.

5 - Open it like it was a book. If done correctly the top of the inside pages should be at the top. and the GREY PDF PAGE NUMBER “1” should be on the

lower, LEFT HAND corner area (inside MANUAL PAGE NUMBERS should be “2” on the left and “43” on the right). Test again as necessary to get it right..

(continued on other margin)

PRINT THIS PAGE FIRST - THEN READ DIRECTIONS

Need help?

Do you have a question about the ELNA SP and is the answer not in the manual?

ELNA SP Specifications

General

Type	Electronic
Stitch Length Control	Yes
Stitch Width Control	Yes
Stitch Options	Multiple
Buttonhole Styles	Multiple
Speed Control	Yes
Presser Feet	Multiple
Display	LCD
Needle Positions	Adjustable
Weight	Approx. 7-8 kg (varies slightly by model)