22
To remove the Vapojet, simply slide it out of the xed handle.
1) Remove the cap and ll it with about ¾ of water.
Do not completely ll the Vapojet.
2) Replace the cap and slide the Vapojet onto the xed handle. Press the lever
rst slowly, then faster until nebulization. Now it’s ready to use.
If at rst use after following step 2 your Vapojet does not nebulize we
recommend:
1. Carefully check that the cap closure is correct. In case open and close again.
2. Position the Vapojet vertically, directly under the sink tap and with the cap
facing upwards.
Open the cap and start the water lling procedure. While lling and remaining
in a vertical position, press the Vapojet lever repeatedly until nebulization.
When in operation, close the cap and hook the Vapojet to your press.
3) Place the garments on the board, spray the Vapojet lever several times and
lower the heating shoe to create natural steam.
N.B: you can perform the spraying operation even while you are lowering the
heating shoe.
For an optimal use of the Vapojet consult the video tutorial on
www.elnapress.com.
1)
USING THE VAPOJET
2)
3)
To Next Page
Loading...
