6
IMPORTANT SAFETY INFORMATION
Read all instructions before using your Elnapress. Elnapress is reserved
exclusively for domestic use.
To avoid risk of electric shock, burns, re or personal injury:
— Lock Elnapress before moving or transporting it.
— Never immerse the press in water or other liquid.
— Carefully follow the instructions for use.
— Do not use the press if damaged; do not try to repair or disassemble it.
For repair, contact a qualied technician. Improper repair or reassembly may
cause one of the risks listed above or void the warranty.
— Never use Elnapress if the cord or press is damaged. Replace the cable
with another cable supplied by an Elnapress authorized dealer.
— Connect the press only to a grounded wall socket.
If an extension cord is needed, make sure the amperage is the one intended
for Elnapress. A cord with a lower amperage may overheat.
Use only one extension cord with grounding. Make sure that the cord is not
inadvertently pulled or mishandled.
— In case of transport, make sure that the power cord is disconnected from
the press.
— To avoid overloading the circuit, do not use another high-voltage device at
the same time.
— The cable must not touch a hot surface.
— Allow the press to cool completely before closing it and storing it.
— This appliance may be used by children over 8 years of age and by persons
with reduced physical, sensory or mental abilities or lack of experience and
knowledge if safely supervised or instructed on the use of the device and
understand the dangers involved.
— Children must not play with the appliance.
— Cleaning and maintenance of the press must not be performed by children
without supervision.
— After use, immediately unplug the plug; to remove it, pull the plug, not the
cord.
— Read the maintenance chapter before cleaning your Elnapress. There is a
risk of burns if the hot shoe is touched.
To Next Page
Loading...
