User Manual – 2201L
SW601363 Rev E, Page 6 of 23
Touchmonitor Connections
1. Connect the DVI or VGA video cables between the monitor’s DVI/VGA input connectors and
your DVI/VGA video source, respectively. Tighten the video cable’s screws for best
performance.
2. Connect the USB touch cable between the monitor’s USB connector and your PC’s USB
port.
3. Connect the audio cable between the monitor’s Audio In jack and your audio source.
4. Select the correct power cable for your region. Connect the cable between the AC power
source and the power adapter’s input connector. Connect the power adapter’s DC output
connector to the monitor’s input power jack.
5. Replace the cable cover, if desired. Cables can be routed inside the stand – remove and
replace the stand cable cover for access and routing.
6. The touchmonitor ships in an OFF state. Press the power button to turn it on.
To Next Page
Loading...
Need help?
General