2
G: H shows that the reading is “Held” and the unit will turn itself off after 10
seconds of inactivity. A round blob “●” shows the unit is in continuous reading
mode until a button is pushed, nothing here means that a single reading is being
taken.
The L indicates logging is in operation (later firmware versions)
A battery level gauge appears at B.
The above format is slightly different for some parameters and can be altered by the
user if required, see below.
The current time and date can be hidden by pressing Set\Clock\Hide-Unhide.
Set Button
The blue Set button is used to access advanced functions, change units etc. If it is
pushed once a menu similar to that below is shown:
MENU
Show>
Data log>
Display>
Units>
Clock>
Battery>
Setup>
About
The first menu item “Show” is highlighted, different menu items can be highlighted
using the and buttons. The wanted action is done by highlighting the appropriate
menu item and pressing the Set button. To abort without doing anything press the X
button. In some cases a further sub-menu is displayed with more choices.
Elsewhere in this manual directions in the form Set\item1\item2 are given. This means
Press Set, select item1 in the first menu, press Set again, select item2 in the next menu
and press Set.
To Next Page
Loading...