Elsema WK433 - Operation; Programming the Keypad Code

Operation
Both channel 1 & 2 have the same code. After typing the correct code combination,
pressing button transmits channel 1 and pressing the button will transmit channel 2.
Buzzer
Description
1 short beep
When any button is pressed
1 long beep
Correct combination typed in
5 short beeps
Incorrect combination typed in
Low or no buzzer
Battery needs replacing
Programming the keypad code
Factory default code is 1234. Do not use the factory default code for normal operation.
Procedure
Buzzer
1. Press and hold “0”
1 short beep
2. While holding “0’ press and release
1 long beep
3. Release “0”
4. Type in the factory default code (1234)
and press
Short beeps when typing
5. Type in your new code combination which
can be up to 8 digits and press
Short beeps when typing
6. Type the new code combination again to
confirm and press
1 long beep when button is
pressed
During normal operation, code combination should be pressed with-in 5 seconds of
each other. If a wrong combination is pressed, press either or and start over
again.