Need help?Do you have a question about the Elster MR HP20 and is the answer not in the manual?
General| Pressure Range | 0-20 bar |
|---|---|
| Output Signal | 4-20 mA |
| Power Supply | 24 VDC |
| Protection Class | IP65 |
| Housing Material | Aluminum |
| Type | Pressure Controller |
Details on the naming convention and structure of product models.
Lists the materials used for various components of the regulator.
Specifies the available spring ranges for regulators and safety shut-off valves.
Provides step-by-step instructions and guidelines for installing the regulator.
Recommendations for the downstream pressure line volume for optimal regulator dynamics.
Details on how to properly connect sensing and other function lines to the regulator.
Guidance on connecting breather lines, especially for enclosed spaces.
Procedure for resetting the safety shut-off valve after operation or maintenance.
Instructions on how to adjust the regulator's setpoints, including changing springs.
Procedures for verifying the correct operation of the regulator and safety shut-off valve.
Method for checking the regulator and pipe connections for leaks.
Steps for safely disassembling the regulator head for maintenance or repair.
Instructions for cleaning the valve seat and associated components.
Procedure for cleaning the spindle guide mechanism.
Steps for replacing the main diaphragm of the regulator.
Procedure for replacing the secondary diaphragm of the regulator.
Steps for reassembling the regulator head after maintenance.
Procedure for assembling the secondary diaphragm into the regulator.
Procedure for assembling the main diaphragm into the regulator.
Steps for assembling the spindle guide back into the regulator.
Procedure for assembling the valve seat and related parts.
Steps for disassembling the Safety Shut-off Valve (SCU) control unit.
Steps for reassembling the Safety Shut-off Valve (SCU) control unit.
Performing a function check after maintenance on the SCU or regulator.
To Next Page
