ELTEX ESR-200 - Page 564

ESR series service routers.ESR-Series. User manual
564
Specify the account (Ivan user) to connect to the server:
esr(config-l2tp)# username ivan password ascii-text simplepass
Specify the remote gateway:
esr(config-l2tp)# remote address 20.20.0.1
Specify a security zone:
esr(config-l2tp)# security-zone VPN
Specify IPsec authentication method:
esr(config-l2tp)# ipsec authentication method pre-shared-key
Specify IPsec security key:
esr(config-l2tp)# ipsec authentication pre-shared-key ascii-text password
Enable L2TP tunnel:
esr(config-l2tp)# enable
To view the tunnel status, use the following command:
esr# show tunnels status l2tp
To view sent and received packet counters, use the following command:
esr# show tunnels counters l2tp
To view the tunnel configuration, use the following command:
esr# show tunnels configuration l2tp