P01
..
Actual Sensor Temp
. °C/°F (disp.only)
P10
..
Control Setpoint
Affects relay 1, range P13...P14, [41°F/5°C]
P11
..
Switching hysteresis from set point (
P10)
range 2..10K [2K]
P12
..
Min. Relay Idle Time (Relay K1)
0..30.0 Min., [0.0 Min], resolution 0.1 min.
P13
Highest Adjustable Control Setpoint
Range min (see P14) to max 734°F (390°C), [734°F/390°C]
P14
..
Lowest Adjustable Control Setpoint
Range -58°F (-50°C) to max (see P13), [32°F/0°C]
P20
..
Sensor/Probe Type
0 = RTD/Pt100, 3-wire, °C (Resolution 1K)
[1] = RTD/Pt100, 2-wire, °C (Resolution 1K)
2 = RTD/Pt100, 3-wire, °F (Resolution 2°F)
3 = RTD/Pt100, 2-wire, °F (Resolution 2°F)
P21
..
Sensor Correction
-30...+10K, [0]
P30
..
High Temp. Alarm Threshold
Min or P31 to 752°F (400°C), [752°F/400°C]
P31
..
Low Temp. Alarm Threshold
-76°F (-60°C) to max or P30, [-76°F/-60°C]
P32
..
Alarm Delay while in Operation
0...99 min., [0.0 Min., Resolution 0.1 Min.]
P33
..
Alarm Delay while Power-on/Energized
0...500 min., [0 min.]
P34
..
Alarm Relay Mode (Relay K2)
0 = Relay ON at probe fault
[1] = Relay OFF at probe fault
2 = Relay works as releasing relay
To Next Page
Loading...
