What to do if Eltron Printer printing stops and POWER indicator lights ORANGE?
If the printing stops and the POWER indicator lights up orange, here are a few things to consider: * Perform AutoSense gap sensor adjustment. * It could be a problem with the label stock; use only Eltron approved labels and tags. * There may be a label jam. * The memory might be insufficient for the label size; check the printer memory configuration.
Why does my Eltron Printer only print a partial label or skip a label?
If your printer is only printing part of a label or skipping labels, consider the following: 1. Perform AutoSense gap sensor adjustment. 2. Check if a label is caught on the print head. 3. Ensure the print head is properly latched. 4. It may be a software problem; check the printer memory configuration.
What to do if Eltron Printer appears to be working, but nothing is printed?
If your printer seems to be working but nothing is being printed, try the following: * Verify that the labels are the correct type (direct thermal or thermal transfer). * For LP models, check that the roll is loaded with the direct thermal side facing up. * For TLP models, check that the ribbon is properly installed. * Clean the print head with a cleaning pen.
General| Resolution | 203 dpi (8 dots/mm) |
|---|---|
| Print Method | Direct Thermal |
| Memory | 8 MB DRAM, 4 MB Flash |
| Media Width | 0.75" (19 mm) to 2.36" (60 mm) |
| Connectivity | USB, Serial, Parallel |
| Supported Barcode Types | Code 39, Code 128, Interleaved 2 of 5, Codabar, UPC-A, UPC-E, EAN-8, EAN-13, Postnet |
| Supported Media Types | tag stock, wristbands |
| Operating Temperature | 41 to 104°F (5 to 40°C) |
| Storage Temperature | -40° F (-40° C) to 140° F (60° C) |
To Next Page
