Regulation Information
¤ CE compliance
This device is classed as a technical information equipment (ITE) in class B and is
intended for use in living room and office. The CE-mark approves the conformity by the
EU-guidelines:
-
EMC Directive 2014/30/EU,
-
Low Voltage Directive 2014/35/EU(equals A2 : 2013) ,
-
RF Directive 2014/53/EU
FCC Information
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE
STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interfer-ence by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the manufacturer or an experienced radio/TV technician for help.
RF Exposure Warning
This equipment must be installed and operated in accordance with
provided instructions. The antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20cm from all persons
and must not be co-located or operating in conjunction with any other
antenna or transmitter.
To Previous Page
Loading...