Preparation
Gently remove the black hex water
stopper caps (already on the LPP).
Keep these caps to transport your
LPP in the future.
Connect the braided water hoses to the LPP. Hand tighten the
hoses ONLY until you begin to feel resistance.
Tools should not and do not need to be used to attach the
hoses.
1.
Read the User Manual entirely before first operating this device.
2.
Distilled water and a small cup to fill the LPP is recommended. We do not
recommended filling directly from a gallon jug of distilled water as the
likelihood of spillage will increase. Do NOT use tap water!
3.
Verify the (black and silver) connectors are attached to the braided water
tubes firmly.
4. Place the LPP on a flat surface.
5. Proceed to remove water stopper caps and connect the water hoses as
__shown below.
To Next Page
Loading...