eMachines Flat Panel Monitor User Manual

Using Your eMachines Flat-Panel Monitor
6
Setting up the optional stand
Attaching the USB stand
In the United States, you can buy an adjustable USB stand from www.gateway.com. You can adjust
the stand for height, tilt, and screen rotation. When the stand is connected to your computer’s
USB port, you can connect up to four USB devices to the USB 2.0 ports on the stand.
To attach the adjustable stand:
1 Make sure that the monitor is turned off.
2 Place the monitor face-down on a stable, soft (non-marring) surface. A non-slip mat on a
tabletop is ideal. Let the monitor base hang down over the edge of the table.
3 Remove the screw from the neck hinge, then remove the neck from the LCD panel.
4 Remove the four small screws from the back of the LCD panel. Save the four screws.
5 Slide the adjustable stand’s neck onto the base.
Screw
Screw
Screw
Screw Screw

eMachines Flat Panel Monitor Specifications

General

Brand	eMachines
Model	Flat Panel Monitor
Category	Monitor
Language	English