eMACROS HS-002 - PIR Motion Sensor

PIR Motion Sensor:
c. Before installing the PIR Sensor, recharge the
sensor (with 18650 battery attached) using the
AC adapter to ensure a full charge. The blue light
will illuminate while charging. The blue light will
turn off once the battery is fully charged.
Note: The sensor has been tested several times in the
factory. If the blue light wont illuminate, the battery
may be fully charged, you can install it directly.
d. High / Low / Off Switch: First, open the black
silicone seal cap at the bottom of the PIR Motion
Sensor, then turn on the sensor by switching to
High or Low. Set the detection range to High (30feet),
Low (20 feet) , or turn sensor Off.
e. CH 1-4 Switch: Select a different channel for
each outside sensor. If installing multiple PIR
Motion Sensors, ensure that each sensor is set
to a different Channel/Zone.
Note: Each Separate channel uses an unique chime,
allowing you to match different chimes with different
channels.
f. Test the PIR Motion Sensor by waving your hand
in front of the sensor. The Base Station will produce
6