EN 27HOW TO USE THE MACHINE
Drive must be engaged in the way already described
(
☛
4.32) to prevent sudden engagement from causing tipping up and
loss of control of the vehicle, particularly on slopes.
5.4.3 B
RAKING
First, reduce the machine’s speed by reducing the engine’s r.p.m. and then push
the brake pedal (☛ 4.21 or 4.31) to further reduce the speed until the machine
stops.
For hydrostatic drive models:
The machine already slows down considerably by just
releasing the drive pedal.
5.4.4 R
EVERSE
Reverse must be engaged ONLY when the machine is stopped.
For mechanical drive models:
Push down the pedal until the machine stops and then insert reverse by
moving the lever sideways and putting it into position «R». (☛ 4.22). Gradually
release the pedal to engage the clutch and then begin moving in reverse.
For hydrostatic drive models:
When the machine is stopped, start the reverse movement by pressing the
drive pedal in the «R» direction (☛ 4.32).
5.4.5 G
RASS CUTTING
When you have reached the area to be mowed, make sure that the grass-catcher
or stone-guard is correctly fitted and that the cutting deck wheels are positioned
at the required height.
Each wheel can be fitted at two different heights: the low position always leaves a
space between the ground and the edge of the cutting deck to prevent the deck
➤
➤
NOTE
➤
!
WARNING!
To Next Page
Loading...