3.3 FITTING THE SEAT
1. Fit the seat (1) onto the plate (2) using the
screws (3).
3.4 FITTING THE BLADE ENGAGEMENT
LEVER
1. Using the bush (1), fit the end of the lever
(2) onto the protruding part of the pin (3);
2. fasten this securely with the screws (4) and
the nuts (5).
3.5 CONNECTING THE BATTERY ( sonly in the electric start models):
The battery (1) is situated under the seat.
1. Connect the battery connector (2) to the
machine connector (3);
2. recharge the battery by following the
instructions in the manual (☛ 6.2.5).
Never start the engine
until the battery is fully charged!
Follow the battery manufacturer's instructions regar-
ding safe handling and disposal.
!
WARNING!
IMPORTANT
➤
EN 9UNPACKING AND ASSEMBLY
To Next Page
Loading...
Need help?
General
