EasyManua.ls Logo

EMAK Oleo-Mac BC 241 D - User Manual

EMAK Oleo-Mac BC 241 D
164 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
I MANUALE USO E MANUTENZIONE
GB OPERATOR’S INSTRUCTION BOOK
F MANUEL D’UTILISATION ET D’ENTRETIEN
D BETRIBS- UND WARTUNGSANLEITUNG
E MANUAL DE USO Y MANTENIMIENTO
SK NÁVOD NA POUŽITIE A ÚDRŽBU
P MANUAL DE INSTRUÇÕES
GR ΕΓΧΕΙΡΙΔΙΟ ΧΡΗΣΗΣ ΚΑΙ ΣΥΝΤΗΡΗΣΗΣ
TR
AŞAĞIDAKI MOTORLAR KULLANIM KILAVUZU
CZ
NÁVOD K POUŽITÍ
RUS UK ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИ
PL
INSTRUKCJA OBSŁUGI I KONSERWACJI

Table of Contents

Questions and Answers

  • J
    Justin EstradaAug 11, 2025
    Why does my EMAK Brush Cutter engine not reach full speed and emit excessive smoke?
    • A
      Alexander GonzalezAug 11, 2025
      If your EMAK Brush Cutter's engine isn't reaching full speed or is emitting excessive smoke, first, ensure you're using fresh fuel with the correct 2-cycle oil mix. Next, inspect and clean the air filter according to the maintenance instructions for the air filter. If the problem persists, the carburetor may need adjustment, so it is recommended to contact a Servicing Dealer.
  • L
    lisanguyenAug 16, 2025
    What to do if EMAK Brush Cutter engine will not start?
    • L
      Linda HodgesAug 16, 2025
      If your EMAK Brush Cutter engine won't start or dies shortly after starting, the issue could be due to a lack of spark or a flooded engine. Check for a spark at the spark plug tip. If there's no spark, try again with a new spark plug (CMR7H). If the engine is flooded, follow the procedure on page 19. If it still doesn't start, repeat the procedure with a new spark plug.
  • T
    Tanya TylerAug 23, 2025
    Why EMAK Brush Cutter starts but will not accelerate properly?
    • M
      martinthomasAug 23, 2025
      If your EMAK Brush Cutter starts but doesn't accelerate properly or run well at high speed, the carburetor may need adjustment. It is recommended to contact a Servicing Dealer for carburetor adjustment.
  • S
    Scott FordAug 28, 2025
    How to fix EMAK Brush Cutter that starts and runs but will not idle?
    • P
      Paul OrrAug 28, 2025
      If your EMAK Brush Cutter starts, runs, and accelerates, but won't idle, the carburetor likely needs adjustment. Turn the idle speed screw “T” clockwise to increase the idle speed. Refer to the Operation-Carburetor Adjustment section for detailed instructions.
  • J
    Jeremy MorrisSep 4, 2025
    What to do if EMAK Brush Cutter engine runs but cutting attachment is not rotating?
    • J
      jenniferortizSep 4, 2025
      If the engine of your EMAK Brush Cutter starts and runs, but the cutting attachment isn't rotating, the clutch, bevel drive, or transmission shaft may be damaged. If necessary, replace the damaged parts and contact a Servicing Dealer.

EMAK Oleo-Mac BC 241 D Specifications

General IconGeneral
Engine Type2-stroke
Displacement21.7 cm³
Weight4.5 kg
Fuel Tank Capacity0.4 L
Shaft TypeStraight
Starter TypeRecoil