English Français
Quick Start Guide
Ematic Blitz Speaker - ESB106
Make sure Bluetooth is on and connected to
the Speaker.
To charge the speaker plug the provided USB Cable
to the USB port on the back of the speaker. Then
connect to a computer or USB charger.
While charging, the status light will glow solid
RED. The light will turn off when charging is
complete.
Battery life is approximately 15 hours at moderate
listening levels.
Visit ematic.us/support for customer support
regarding your device.
To submit a request, fill out the required information
online. You will be provided a ticket number
regarding your issue which you can refer to when
contacting us further.
Select a song/video. Speaker will automatically
sync to your device.
Plug the cable from your device to the AUX port on
the back of the speaker.
Receive phone calls when connected through
Bluetooth (audio playback will pause during calls)
Using Bluetooth
Using AUX Cable
While connected to Bluetooth, answer calls
pressing the Call button on top of the speaker.
Answer/End calls:
Press the
While on a call:
Short press the
button.
button to answer.
Ignore call:
Long press the
button to ignore a call.
Redial call:
Long press the
button.
Playing Media
Phone Calls
Charging
Customer Support
©2014 Ematic. iPad®, iPhone® and iPod® touch are registered
trademarks of Apple Inc. IOS is a trademark of Cisco Technology,
Inc. Android is a trademark of Google Inc. The Bluetooth® word
mark, figure mark (stylized “B Design”), and combination mark
(Bluetooth word mark and “B Design”) are registered trademarks
and are wholly owned by the Bluetooth SIG and used by Ematic
under a license. Ematic is not affiliated with Apple, Inc. Cisco
Technology, Inc, or Googe, Inc., (including Android). The Ematic
brand and products are owned by Shaghal, Ltd.
Slide the switch on the back of the
speaker to ON.
Turn on the speaker. The status light will blink
fast if unconnected, slow if connected.
Go to Bluetooth Settings. Be sure Bluetooth is
active, and tap Blitzspeaker.
“Connected” will display next to Blitzspeaker.
Power Button. Press and hold to turn on
the speaker.
Answer calls directly from the speaker.
Previous Track / Rewind
Play/Pause
Enter the settings app located in the apps menu
and turn on Bluetooth.
Tap Search for Devices.
Tap Blitzspeaker to connect.
Increase Volume
Next Track / Fast Forward
Decrease Volume
Press and hold the power button on
the top of the speaker.
A blue LED on the front of the speaker will begin
blinking and a voice will indicate the speaker is on.
Turn on the Speaker
Speaker Basics
Pairing with your Device
Android™ 4.0/4.4
iOS
®
Blitzspeaker
Using MicroSD
Insert a MicroSD card into the slot on the back of the
speaker. Control playback with the buttons on the
top of the speaker.
To Next Page
Need help?
General
