Step 3: Changing the time delay before auto-sleep
The Embertec 8PC+ software detects when your PC is idle and you
don’t appear to be using it. When this happens, you will be prompted
to either move your mouse or press a key to stop your PC from being
placed into sleep/standby mode.
The default time delay before being prompted is 15 minutes.
To change the time delay, double click on the icon in your system
tray and then select a time period.
NOTE: This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between equipment and receiver
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Any changes or modifications not expressly approved
by Embertec Pty Ltd could void the user’s authority to operate
this equipment.
Optional installation
Specifications
4
To Next Page
Loading...