AIRPLANE
OPERATIONS
MANUAL
NORMAL PROCEDURES
REVISION 40
1-02-17
Page
11
Code
01
AOM-145/1114
BACK-UP TUNING (if installed) ................................... SET
Set to NORMAL and copying RMU2.
COMM 3 (if installed).................................................... SET
Press the transfer button in case of an error message on the radio
display.
Pressurization ............................................................... SET
Set the system to the destination airport elevation and verify that
the DUMP and AUTOMAN switches are guarded and were not
pushed (if they have been pushed the white mark on the buttons
will be lit). The manual controller knob must be set to the green
mark (DN position) to enable automatic pressurization control.
FMS .............................................................................. SET
The PF assigned for the flight must enter all the data that does not
depend on the final ship papers. So the FMS initialization including
the check if the DATABANK is still valid, check for correct date and
time and check for possible messages related to the status of the
FMS. Also if the flight plan needs to be entered, it can be done
now.
NOTE: For UNIVERSAL FMS operations, in order to prevent CDU
DATA BUS FAIL massage from occurring, a crossfill operation
should be performed only after the airplane is energized by its
generators (APU and/or engines), provided that airplanes
buses are stable and already supplying power to the systems
(GPU is disconnected).
AFTER THE FINAL SHIP PAPERS ARRIVE ON BOARD – SHORTLY
BEFORE STARTUP:
FUEL QTY .................................................................... CHECK
Confirm if onboard fuel quantity matches required fuel for the
intended flight.
FMS .............................................................................. SET
The LSP must complete data entry into the FMS including TOTAL
FUEL, CARGO DATA and PAX NUMBER.
Speed Bugs .................................................................. SET
Set V
1
, V
R
, V
2
and V
APP
on the MFD. Set V
FS
on the PFD.
In case of Noise Abatement procedure set V
2
+10 on the PFD.
To Next Page
Loading...
