Personnel
WARNING!
Only authorized and qualified persons should undertake service/maintenance.
To reduce the risk of injury:
•
Do not attempt any type of maintenance or repair before reading and understanding all information,
cautions and warnings in this material.
•
Use protection when working on the vehicle. Use extra caution when working around batteries or using
solvents or compressed air. Use eye protection, hand protection, foot protection, body protection or any
other safety equipment based on the maintenance being carried out on the vehicle.
•
To reduce the possibility of an electrical arc (can result in battery explosion), disconnect all electrical
loads from the battery before removing the battery cables.
•
Wrap wrenches with vinyl tape to reduce the possibility of a dropped wrench ‘shorting out’ a battery, which
could result in an explosion.
•
Remove, ground and disconnect battery wires at the negative terminal before servicing to reduce the
possibility of accidental starting.
•
Electrolyte spills should be neutralised by flushing the area with a solution of 2 teaspoons (10ml) sodium
bicarbonate (baking soda) dissolved in 1 litre of water.
•
Extreme caution must be used when using aerosol containers of battery terminal protectant. Insulate the metal
container to reduce the possibility
of any contact
with the battery terminals
which could result
in an
explosion.
•
It is in the best interest of the vehicle owner and service technician to carefully follow the procedures
recommended in this material. Preventative maintenance applied at regular intervals is the best guarantee
for keeping the vehicle both dependable and economical.
•
Only qualified, trained and authorised personnel should be permitted to inspect, adjust and maintain
EMC Vehicles.
Vehicle cleaning
WARNING!
•
If using a pressure washer, ensure all instructions supplied by the manufacturer are read and understood
before operation to reduce the possibility of severe injury or damage to the vehicle.
Caution: When pressure washing exterior of vehicle, do not use high pressure settings. To reduce
the possibility of cosmetic damage, do not use any abrasive or reactive solvents when cleaning,
particularly on any plastic parts.
•
Ensure correct techniques and cleaning materials are used. Using excessive water pressure may cause
severe injury to operator or bystander, damage to seals, plastics, seat material, body finish or electrical
system.
•
Clean windscreen with lots of water and a clean cloth. Minor scratches may be removed using a commercial
plastic polish.
•
To clean vinyl seats and plastic or rubber trim, apply a mild soap solution with a sponge or soft brush and
wipe with a damp cloth.
•
Removal of oil, tar, asphalt, shoe polish, etc. will require the use of a commercially available vinyl/rubber
cleaner.
•
The painted surfaces of the vehicle provide the vehicle with anattractive appearance and durable protection.
Frequent washing with lukewarm or cold water and mild detergent is required to preserve the painted
surfaces.
•
Occasional cleaning and waxing of the vehicles painted surfaces with non-abrasive products designed for ‘clear-
5
coat’ automotive finishes will enhance the appearance and durability.
•
Some corrosive materials such as fertilisers can collect in the underbelly of the vehicle. These materials will
cause corrosion of underbody parts unless flushed occasionally with water. Thoroughly clean any areas
where mud or other debris can collect. Sediment packed in closed areas should be loosened to ease its
removal, taking care not to chip or otherwise damage paint.
To Next Page
Loading...
General