EMC VNX5500 - 2 U, 25 (2.5-inch) DAE front view

Disk-array enclosure
VNX5500 Hardware Information Guide 81
Table 44 describes the bus (loop) indicator status LEDs.
2U, 25 (2.5-inch) DAE front view
On the front, the Block and File (Unified) VNX5500 platform 2U, 25 (2.5-inch) DAE (DAE5S)
includes the following hardware components:
◆ 2.5-inch 6-Gb/s SAS, 6-Gb/s NL-SAS, or Flash disk drives (hot-swappable)
1
◆ Status LEDs
Figure 71 shows the location of these components.
Figure 71 2U, 25 (2.5-inch) DAE (front view)
Note: In a Block and File (Unified) VNX5500 platform, when using the 2U, 25 (2.5-inch)
disk drive carrier, the maximum amount of disk drives is 250 (includes DPE and expansion
DAEs).
Table 44 LCC bus (loop) status LEDs
Led Color State Description
Power fault Amber On Fault
— Off No fault or power off
Power on Green On Power on
—OffPower off
1. You can add or remove a disk drive while the DAE is powered up, but you should exercise special
care when removing modules while they are in use. Drive modules are extremely sensitive
electronic components.
1 2.5-inch 6-Gb/s SAS or 6-Gb/s NL-SAS
drives
4 Disk drive fault LED (amber)
2 DAE fault LED (amber) 5 Disk drive status/activity (blue)
3 DAE power status LED (blue)
1
4
VNX-000276
5
2 3