Need help?Do you have a question about the EMC VNXe3200 and is the answer not in the manual?
General| Form Factor | 2U |
|---|---|
| Maximum Drives | 150 |
| Drive Types | SSD, SAS, NL-SAS |
| RAID Levels | RAID 0, 1, 5, 6, 10 |
| Maximum Number of LUNs | 256 |
| File Protocols Supported | NFS, CIFS |
| Redundancy | Dual Controllers |
| Protocols | CIFS, NFS, iSCSI |
| Host Connectivity | 1 GbE, 10 GbE |
| Block Protocols Supported | iSCSI, FC |
| Management | Unisphere |
| Operating System | EMC VNXe Operating Environment |
Instructions for unpacking the Disk Processor Enclosure (DPE) and verifying its components.
Guide to unpacking optional Disk Array Enclosures (DAEs) and their contents.
Prerequisites and initial considerations before starting the system installation process.
Details the site, power, network, and tool requirements for system installation.
Procedures for installing the rails for the Disk Processor Enclosure (DPE).
Steps to physically mount the Disk Processor Enclosure (DPE) into the rack.
Instructions for installing the rails for optional Disk Array Enclosures (DAEs).
Procedures for physically mounting the Disk Array Enclosure (DAE) into the rack.
Guide for connecting the Disk Processor Enclosure (DPE) to Disk Array Enclosures (DAEs) with SAS cables.
Steps to connect the system's storage processors to the network using Ethernet cables.
Detailed instructions for powering on the installed VNXe system components.
Guidance on checking system LEDs to confirm correct power-up and operational status.
Instructions for attaching front bezels to the installed system components.
How to connect a computer to the VNXe for initial configuration and management.
Steps to obtain a management IP address via DHCP and DNS.
Procedure for manually configuring a static IP address using the Connection Utility.
To Next Page
