Need help?Do you have a question about the EMC Celerra NX4 and is the answer not in the manual?
Introduces system software and outlines site preparation tasks.
Details the private IP network configuration and default addresses for system components.
Visual overview of the installation process from ordering to assembly and software.
Overview of the implementation phase focusing on post-installation configuration.
Detailed breakdown of installation steps with estimated durations.
Describes configuring the system for production after initial setup.
Instructions for unpacking the system from its shipping container.
Lists components and documents found within the disposable mini-rack.
Step-by-step guide for safely removing system components from the container.
Instructions for removing and installing ganged rail components into the server rack.
Details on installing system components, securing them, and attaching bezels.
Illustrates and describes the two types of blade enclosures supported by the NX4 system.
Diagram showing Fibre Channel port connections between blades, SPs, and DPE.
Illustrates cabling for standby power supply (SPS) and MODEM ports.
Shows how to cable the dual blade private local area network (LAN) ports.
Details the cabling for the dual blade public local area network (LAN) ports.
Instructions for cabling up to four optional disk-array enclosures (DAE).
Step-by-step guide to powering up the system with dual standby power supplies.
Visual diagram illustrating the power cabling for a dual SPS system configuration.
Detailed steps for powering up the system with a single standby power supply.
Diagram illustrating the power cabling for a single SPS system configuration.
Detailed cabling diagram for systems using four port copper Ethernet blades.
Diagram showing cabling for blades with 10 GbE optical and two port copper interfaces.
Locations and meanings of light emitting diodes (LEDs) on system components for status verification.
Worksheet to record LAN settings and passwords for Celerra Startup Assistant installation.
Continues the worksheet, covering blade/SP IP addresses, notification info, and software licenses.
Section to record network configuration details for provisioning unused disks.
Worksheet section for creating NFS (UNIX/Linux) exports using the CSA.
Worksheet section for creating or attaching iSCSI LUNs using the CSA.
Worksheet section for creating or attaching CIFS (Windows) shares using the CSA.
Requirements and steps for downloading and installing the Celerra Startup Assistant software.
Instructions on launching the CSA and proceeding to the "Configure for Production" step.
To Next Page
General
