EMC Celerra NX4

26
For more information, refer to Celerra Tools on http://Powerlink.EMC.com
CSA installation worksheet
Note: The dial-in modem number is the phone number for the line that connects to the
modem. This is the local number that is used by the service provider to dial into your system.
Note: Email will not work without a DNS server.
3. The appropriate blade public LAN settings are auto-discovered.
4. Record the storage processor public LAN IP addresses.
DNS domain
Primary DNS server
Secondary DNS server
NTP server
SP A IP address
SP B IP address
Note: Public IP addresses for your storage processors are required for use with the
Navisphere Service Taskbar for routine array maintenance and upgrades. In addition,
for Celerra systems where Navisphere licenses are in place, Navisphere can be
used to manage storage for external host connectivity, and the Celerra. However, we
recommend users manage Celerra storage using the Provisioning wizard capability
within the CSA or within Unisphere software. The IP addresses must be on the same
subnet as the Control Station.
5. If applicable, confi gure service provider/customer notifi cation information.
Service provider/
customer notifi cation
Email Server (recommended)
Recipient Email Addresses (optional)
Site information Site ID (optional) (party name)
Dial-in Modem # (optional)
Note: These settings apply to all primary blades.
6. Check the boxes of the licenses that you have purchased.
 CIFS (Windows)
 NFS (Linux)
 iSCSI
At this point, the installation and pre-confi guration portions of CSA are complete.