EMC Celerra NX4

25
For more information, refer to Celerra Tools on http://Powerlink.EMC.com
CSA installation worksheet
1. Record the appropriate Control Station public LAN settings.
Primary hostname
Primary IP address
(For second Control Station only)
Secondary hostname
(For second Control Station only)
Secondary IP address
Netmask
Gateway
DNS domain
Primary DNS server
Secondary DNS server
NTP server
Time Zone
The CSA pre-populates values based on auto-discovery from your Windows client. Shaded
fi elds below are values that will be auto-discovered based on your system and network
environment; if auto-discovery fails, you need to provide the information manually.
Complete the worksheet and use this information to install using the Celerra Startup Assistant
(CSA). Download the latest version of the CSA from the Celerra Tools section of Powerlink.
Getting Started with the Celerra Startup Assistant can be downloaded from Powerlink and
provides more information on the CSA pre-confi guration and provisioning processes.
2. The passwords for the root user/system back-end administrator and NAS administrator
are default factory values and should be changed as soon as possible for security reasons. The
passwords can be changed during the CSA installation process or later, from within Unisphere.
root_password (default value = nasadmin)
NAS Administrator (default value = nasadmin)
Field Value
Note: If you want to confi gure the IPv6 addresses for the Control Station (Control Station
address, DNS, or NTP) or for the Data Movers (DNS or NTP), use the CSA for the initial
installation and then refer to the Confi guring and Managing Celerra Networking technical module
and Celerra Network Server Command Reference Manual to complete the IPv6 additions.