EMC Celerra NX4

32
For more information, refer to Celerra Tools on http://Powerlink.EMC.com
Celerra Startup Assistant
Step 5: Confi gure for Production
Now that the CSA pre-confi guration is complete, you must confi gure the system
for production. You can use the Provisioning Wizard in the CSA, one of several
pre-packaged implementation confi gurations based on common usages, or
your own implementation using Unisphere software to confi gure your system.
At the end of each of these confi gurations your system will be ready for
production.
Common implementations include:
• Create CIFS shares
• Create iSCSI LUNs
• Create NFS exports
• Add additional hosts for Fibre Channel enabled systems.
• Preform Common Post-CSA tasks.
Go to the Celerra Tools page for the NX4 on Powerlink and select
Step 5: Confi gure for Production, for more information.
Run the Celerra Startup Assistant (CSA)
To run the CSA:
3. Double-click the Celerra Startup Assistant shortcut on the desktop or go to
C:\ProgramFiles\EMC\CSA\startup\launch.bat.
4. Click Install. The Celerra Startup Assistant guides you through the remaining steps.
5. Then confi gure your system as described in “Step 5. Confi gure for Production”.