EMC2 Data Domain DD2500 - Port layout; Power supply units

Port layout
Figure 5 Port numbers on back panel
1. Physical 4, logical ethMe (10GBaseT).
2. Physical 2, logical ethMc (1 GE).
3. Physical 0, logical ethMa (1 GE).
4. Service network port.
5. Physical 5, logical ethMf (10GBaseT).
6. Physical 3, logical ethMd (1 GE).
7. Physical 1, logical ethMb (1 GE).
8. USB port.
9. Serial port (DB-9, RS-232).
Power supply units
A system has two power supply units, numbered 0 and 1 from left to right. Each power
unit has LEDs (shown in the photo) that indicates the following states:
l
AC LED (top): Glows green when AC input is good.
l
DC LED (middle): Glows green when DC output is good.
l
Symbol “!” (lower): Glows solid amber for fault or attention.
Figure 6 Power supply unit LEDs
Installation and Setup Guide
8 Installation and Setup Guide