OPERATING INSTRUCTIONS (continued) - 4 -
Use
96-SL model - Turn on the power switch.
96-DL model - Turn on the power switch. Adjust the heat output with the Dimmer Control clockwise to increase the heat intensity.
96-TDL model - Turn on the power switch. Set the Time Adjustment Control to the amount of time you want the lamp to
stay on.
Push the Timer Start Button. Adjust the heat output with Dimmer Control clockwise to increase the heat intensity.
Infant Eye Protection
The bulbs supplied emit infrared radiation and wavelengths from the visible spectrum (with little, if any, ultraviolet). If the lamp is
to be used for an extended period on infants, we suggest shielding the infant's eyes with an opaque material
MAINTENANCE
Bulb Replacement
Loosen the retaining knobs on either side of the lamp housing. Gently pull the bezel down and allow it to hang by the retaining wire
while you unscrew the bulb. After installing a new bulb of the same wattage (use Emerson part number 648-3002), push the bezel
back on, aligning the slotted holes with the retaining knobs and tighten the knobs securely.
Cleaning
Use mild detergent and a damp rag to clean the exterior surfaces of the light, being careful not to allow any fluid to enter the bulb
socket or the control.
Caution
Do not use spray cleaners or disinfectants or a wet rag or sponge to clean the control panel, since liquid can and will enter the
controls and may cause a malfunction.
To Next Page
Loading...