38 100-214-294 REV. 05
6.4.1 CPX Explanation of Controls
Figure 6.3 CPX Series Controls
Table 6.10 CPX Series explanation of controls
Control Function
Main Power
Switch
This switch is located on the back of the unit, next to the power cord
receptacle.
• Press the on side to power on the unit
• Press the off side to power off the unit
When operating the unit, normally leave the Main Power switch in the on
position, and use the On/Standby key to switch between the operating
state and standby state.
On/Standby
When the Main Power switch on the rear panel is in the on position, press
to power on/off the unit.
Up/Down Keys
Press to increase/decrease ultrasonic or degassing cycle time (hold for
quick increments/decrements).
Time values are circular, pressing Up from 99 minutes takes you to
Constant Sonics Mode (Constant Sonics icon and “- -” display on the
LCD) and then to 1 minutes. Pressing Down from 1 minutes takes you to
Constant Sonics Mode and then to 99 minutes.
During power-up, use to select high or low ultrasonic power output.
To Next Page
Loading...