Emerson CK5038 - Installing the Battery; Power Failure Indicator

5
TO INSTALL THE BATTERY
• Open the battery compartment cover on the
bottom of the radio by sliding the cover in
the direction of the arrow.
• Connect the 9-volt battery to the battery
terminal. It can only be connected one way.
• Push the battery into the battery compartment and replace the cover.
POWER FAILURE INDICATOR
If no battery is installed in the radio, or if the battery in the compartment is weak or
dead, the time and alarm settings will be lost if the power is interrupted. When the
power is restored the clock display will begin flashing. This is your indication that
the time display is incorrect and needs to be reset.
Important:
After you reset the time, be sure to reset your alarm settings as well.
S
L
I
D
E
T
O
O
P
E
N
CK5038_032404.p65 24/3/2004, 11:275