1592025050 iProChill v2.5 10D00 AG v1.3 GB 18.02.2016.docx iProCHILL 24/205
In this screen it is also possible to verify (but not modify) whether the energy saving mode and dynamic set
are active. If they are active, the real set may different from the Cooling or Heating set.
Cooling (Heating) set is always the same as par ST01(ST04), the real set represent the set-point value
including the energy saving delta or of the dynamic set, and it is read only (can’t be modified).
If heat recovery is enabled (RC01>0), the recovery set point will also shown in this screen.
Press the ESC key several times to go back to the main screen.
To Next Page
Loading...
