Need help?Do you have a question about the Emerson Dixell iProChill IPC115D and is the answer not in the manual?
General| Brand | Emerson |
|---|---|
| Model | Dixell iProChill IPC115D |
| Category | Controller |
| Language | English |
Guidelines for the disposal of electrical and electronic waste according to EU directive.
Overview of the primary functions and capabilities of the controller unit.
Instructions for turning the unit ON/OFF and selecting cooling/heating modes via the keyboard.
Using the Real-Time Clock (RTC) for automatic unit ON/OFF scheduling.
Operating the unit in condensing unit mode, noting disabled functions.
Using the SET key to adjust cooling and heating set-points from the main screen.
Accessing and managing alarms from the main screen, including silencing and resetting.
Accessing the service menu for configuration, parameters, and diagnostics.
Instructions for ON/OFF control and mode selection using the Visotouch interface.
Utilizing the Real-Time Clock (RTC) for automatic unit ON/OFF scheduling.
Operating the unit in condensing unit mode, noting disabled functions.
Accessing and managing alarms from the main screen, including silencing and resetting.
Accessing the service menu for configuration, parameters, and diagnostics.
Step-by-step guide for installing the Wizmate configuration software.
Steps for scanning devices, reading, changing, and saving parameter values.
Configuration of onboard and expansion digital inputs (DI).
Configuration of onboard, XEV20D, and expansion analogue inputs (AI).
Configuring 0-10V proportional outputs for various functions like fan speed control.
Calibrating analogue input values to ensure accurate measurements.
Identifying and handling alarms related to probe configuration or out-of-range values.
Managing low pressure alarm delays, operations, and intervention limits.
Detecting and managing high condensation temperature or pressure alarms.
Handling compressor overload alarms, including reset procedures and passwords.
Managing defrost alarms, including reset conditions for temperature or time expiry.
Table detailing alarm conditions for outputs in Circuit 'A'.
Table detailing alarm conditions for outputs in Circuit 'B'.
Table detailing alarm conditions for outputs related to 'C' compressors.
To Next Page